![]() There is a button on the top of the block, used to switch between three operation modes, where the fans are set at minimum, medium or high speed. In Figure 7, you see the connector for the two fans used by the H80, which controls them. This system must be purchased separately.įigure 6 also shows the cables of the block: one four-pin standard peripheral power connector (“Molex”) that powers up the H80, and a single wire that must be connected to the motherboard, allowing it to sense the pump speed. The connector you see in the side of the block allows you to connect the H80 to the Corsair Link, a modular system that controls case cooling and lighting, and can be controlled via an USB port. As in other sealed systems, the pump that makes the liquid flow is integrated in the block. This radiator supports two 120 mm fans and is intended to be installed at the rear panel of the computer case.įigure 6 presents the CPU block, which transfers the heat from the processor to the liquid. This means the system doesn’t need any maintenance.įigures 4 and 5 reveal the radiator, which is responsible for dissipating the heat from the liquid to the air passing through it. As with any sealed liquid cooling system, the block, radiator, hoses, and pump come preassembled, with the coolant liquid already inside. This watercooler is discussed in detail in the following pages.įigure 3 shows the main set of the H80. The H80 box is large and in dark colors, as you can see in Figure 1.įigure 2 reveals what comes in the box: the preassembled radiator-hoses-block-pump system, fans, manual, and installation hardware. Let’s test it and see if it offers great performance.Īlthough it is sold with the Corsair brand, this product is actually manufactured in partnership with CoolIt Systems. The Corsair H80 is a sealed liquid cooling system, a.k.a.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |